Products

3/4" I.D. Collar | Part Number: PU-2X570

$16.50

3/4" I.D. Auger Shaft Locking Collar for pellet stoves. Price listed is for one piece (two pieces are on each...

9 " X 9" Nickel Window Trim | Part Number: AC-106-PBN

$62.43

Nickel Window Trim. Comes with clip for installation.Note: Shown on 55-SHP10L, works on any stove (wood, pellet, coal or furnace)...

Auger Bearing Gasket | Part Number: PU-ABG

$18.79

Auger Bearing Gasket. For stoves built 2001 or before. Fits on block bearing (see Part Number PU-UCF204-12). Fiberglass (soft) material....

Auger Bearing Gasket, Nylon | Part Number: PU-ABGN

$18.79

Auger Bearing Gasket. For stoves built 2002 or later. New (harder) material, replaces PU-ABG. Fits on block bearing (see Part...

Auger Motor (1 RPM) | Part Number: PU-047040

$163.65

1 R.P.M. Auger Motor for Pellet Units. England's Stove Works genuine 1 RPM replacement auger for our stoves. NOTE: Also...

Auger Motor and Auger Bearing Gaskets Kit | PU-ABGMotor1

$168.07 $182.44

PU-ABG (soft, fiberglass) gasket and 1 RPM auger motor PU-047040

Auger Motor and Nylon Bearing Gasket Kit | PU-ABGNMotor1

$168.07 $182.44

(1) PU-ABGN auger bearing gasket and (1) 1-RPM auger motor PU-047040

Auger Motor Gasket Support | Part Number: PU-AMS

$18.79

Auger Motor Gasket Support Sleeve. Fits around outside air intake, Lower Auger Motor rests on it.

Auger Motor Shelf for Pellet Units | Part Number: PU-MS

$17.26

Auger Motor Shelf for Pellet Units for the Corn Stoves, American Heritage Series and American Standard Series (10-CDV, 49-SHC22, 49-TRC22,...

Back Plate Support Bracket | Part Number: STB-PI-SB

$86.79

Back Plate Support Bracket for the Pellet Fireplace Insert (25-PI, 55-SHP20 or 55-TRP20) NOTE: ONLY AVAILABLE ON STOVES MADE 9/19/2016 OR...

Backplate Gasket Kit for 24-JC, 25-PI, 13-NCI | Part Number: AC-PGK

$25.84

Fireplace Cover Plate (backplate) gasket kit. **NOTE: For fireplace insert model only; not for Freestanding models.

Black Silicone, 3 oz. Tube | Part Number: AC-RTV3

$24.50

3 oz. tube black silicone. Tested to 425 degrees F.See below for video instructions regarding this part on various models....

Black Spray Paint, ( 7001 ), ORM-D | Part Number: AC-MBSP

$32.85

High-temperature black spray paint. 12 oz. can. NOTE: By law, this item can only be shipped UPS Ground (even if...

Block Bearing 3/4 " Bore | Part Number: PU-UCF204-12

$43.77

Auger Bearing (block bearing) for pellet units. 3/4" bore. Price listed is for one piece (two pieces are on each...

Bottom Auger for PDV-P-I / SHP 15-20-22 (pre 2001) | Part Number: PU-AF12B

$54.26

Bottom Auger. For 1992-2000 models. For models 2001 and later, order PU-AF11B. For models before 1992, please call Customer Service...

Bottom Auger for PDVC/SHP10 | Part Number: PU-AF11B

$54.26

Bottom Auger. For all 25-PDVC/55-SHP10/55-TRP10 units. Also for ALL pellet models 2001 and later.NOTE: For models 1992-2000, and other than...

Bottom Auger | Part Number: PU-AF13B

$55.48

Bottom Auger. For some 1992-1995 pellet models (refer to your owner's manual to verify part number). NOTE: Does not include...

Brushed Nickel Knob for Ash Drawer / Cover Plate | Part Number: AC-03BN

$18.56

Brushed Nickel knob for ash drawer. Shown on ash drawer, also for cover of pellet insert (hopper) and gas cover...

Burn Pot (Firepot) for PDV & PI | Part Number: PU-BP02A

$111.55

Burn Pot (firepot) Assembly. This is a one-piece unit, which is the burn pot only (not the "feeder pot") for...

Burn Pot FLange Gasket | Part Number: PU-BPG

$22.66

Burn Pot Flange Gasket. Fits between the burn pot and the rear of the stove. NOTE: Please enter your stove's...

Cartridge Heater Assembly - Igniter, and Collar | Part Number: PU-CHA

$83.31

Cartridge Heater (igniter) element for Auto-Start pellet units (Auto-Start units have manufacture date of 2004 or later). Comes with locking...

Cast Feeder System for 04 and Later | Part Number: CA-FS04

$326.54

Cast Feeder Pot Assembly. This is a one-piece unit, which is the feeder pot assembly (not the "burn pot") for...

Combustion Blower and Motor Gaskets | Part Number: PU-CBMG

$27.35

England's Stove Works genuine replacement gasket for our Exhaust (Combustion) Blower. Contains the following two items:1. Combustion Blower Gasket. Fits...

Convection Blower for Certain Pellet Models | Part Number: PU-4C442

$163.65

IMPORTANT: For all pellet models listed on this page except 2002 and newer "Deluxe" freestanding and insert pellet models ("Deluxe"...

Convection Blower | Part Number: PU-4C447

$185.90

Convection (Room Air) Blower. 250 cfm. **NOTE: For all models listed on this page - including Corn/Multifuel Stoves, Pellet Utility...

Digital Control Board for Pellet (2004) | Part Number: PU-CB04

$257.21

Digital System Control Board (rear of board is pictured). For models manufactured 2004 or later (auto-start igniter models). (For models...

Digital Control System Control Board ( 1998 ) | Part Number: PU-CB98

$257.21

Digital System Control Board. For models manufactured before 2004. (For models manufactured 2004 or later, see PU-CB04.)**NOTE: Please specify your...

Digital Wall Thermostat | Part Number: PU-DTSTAT

$75.04

• Info
• Installation

• Digital Wall Thermostat. Can be used on all of our pellet units, as well as our multi-fuel unit.
  Mercury-Free!
  Comes with proprietary instructions for installing on our units.
  NOTE: Does NOT turn pellet stove On & Off, it does increase or decrease the pellet feed rate as needed.
  EXCEPTION: For our multi-fuel model and our pellet models with "EP," "IP" or "PAH" in model number, will turn entire unit on & off as needed OR use a "High/Low" mode of operation (download your stove's owner's manual and call Tech. Support if you have questions).

• See below for video instructions regarding this part on various models. An instruction sheet will also accompany the part, and you may dial (800) 245-6489 (or visit www.heatredefined.com) with any questions.

  Stoves with EP or EPI in model number:

  Stoves with IP in model number:

  Stoves with PAH in model number:

Door Gasket Kit (Models After July 88) | Part Number: AC-DGKC

$35.55

England's Stove Works genuine replacement door gasket for our stoves. Door Gasket Kit for models manufactured after July 1988. (Note:...

Door Gasket Kit | AC-GGDGKC

$51.55 $54.45

Includes AC-DGKC Door Gasket Kit and AC-GGK Window Glass Gasket Kit. For all stoves listed on this page. Remember to...

DuraVent PelletVent 1' Adjustable Section of 3" Pellet Pipe | Part Number: AC-3012A

$51.98

One-foot (1') long section of 3" pellet vent pipe. How it works: Use when a fixed length of pellet vent...

DuraVent PelletVent 1' Section of 3" Pellet Pipe | Part Number: AC-3012

$43.74

One-foot (1') long section of 3" pellet vent pipe; uses the "twist lock" connection. Gives 3" clearance to combustibles, and...

DuraVent PelletVent 3" Pellet Vent Adapter | Part Number: PU-3079

$33.29

3" Pellet Pipe Adapter. Adapts into appliance outlet, allowing pipe to easily connect or disconnect. Can be used for horizontal...

DuraVent PelletVent 3" to 6" Increaser | Part Number: AC-3074

$81.47

AC-3074 Dura-Vent 3" to 6" increaser is for connecting to premanufactured pipe chimney only, not for connecting to masonry chimney....

DuraVent PelletVent 3' Section of 3" Pellet Pipe | Part Number: AC-3036

$64.23

Three-foot (3') long section of 3" pellet vent pipe; uses the "twist lock" connection. Gives 3" clearance to combustibles, and...

DuraVent PelletVent 45 Degree Elbow for 3" Pellet Pipe | Part Number: AC-3045

$62.49

For 3" pellet vent pipe. 45 degree elbow is ideal for corner installations (to connect cater-cornered stove to a through-the-wall...

DuraVent PelletVent 90 Degree Elbow for 3" Pellet | Part Number: AC-3090

$73.48

For 3" pellet vent pipe. 90 degree elbow is ideal for when you need an extra elbow in your installation....

DuraVent PelletVent Clean-Out Tee for 3" Pellet | Part Number: AC-3067

$92.14

Tee with Cleanout Adapter. 3" diameter pellet pipe. Convenient twist-lock connection. Creates 90 degree offset with clean-out access; easy access...

DuraVent PelletVent Horizontal Cap for 3" Pellet | Part Number: AC-3085

$60.79

Dura-Vent Horizontal Cap for 3" pellet vent pipe NOTE: Unfortunately, product is not available for Canada.

DuraVent PelletVent Wall Strap for 3" Pellet Vent Kit | Part Number: AC-3069

$32.89

Dura-Vent Wall Strap for 3" Pellet Vent KitNOTE: Unfortunately, product is not available for Canada.

DuraVent PelletVent Wall Thimble for 3" Pellet Pipe | Part Number: AC-3043

$68.02

Dura-Vent Wall Thimble for 3" Pellet PipeNOTE: Unfortunately, product is not available for Canada.

Flexible Aluminum Intake Air Hose 2" | Part Number: PU-FAH

$36.10

Fuse, 6 amp, for Control Board (set of 5) | Part Number: PU-CBF6

$19.28

Fuse for Control Board. Box of 5.NOTE: Even If you have a stove that was supplied with a 5 amp,...

Glass Kit for MH,TR & All Pellet (w/Gasket) 9 1/8x9 1/8 | Part Number: AC-G9

$96.96

Door Glass Kit. Includes 9 1/8" x 9 1/8" glass, and gasket necessary to install. Shown on 25-PDVC, works on...